Working Principle Of Garment Zipper

clothing

It's very common in our daily life, but few people really understand the principle of the zipper.

The chain teeth of the zippers are different in size and shape, but the chain teeth on the left and right sides of the same zipper must be the same size.

The shape of the zipper head is changeable, which can be used for handle and decoration.

The zipper head can also be used as an insurance. When the zipper is pulled, it will not slide automatically.

The principle of the garment zipper is very simple, that is, the two zippers are carried through.

So that it can be drawn or opened at will, or is locked and opened at will.

The working principle of clothing zipper chain teeth is that each tooth is a small hook, which can match the hole under a small tooth on another cloth belt opposite to it.

The construction of supporting market can absorb the suppliers of surface accessories and processing enterprises. The lack of matching includes two aspects. One is the lack of design talents and management talents. The clothing clothing R & D center is a good attempt, but it is only a drop in the bucket.

To build the entire chemical fiber industry, from raw materials, spinning and weaving to bamboo fiber, bamboo pulp and paper making in Zhongxian, and linen textile in Fengdu.

This zipper is very strong. Only the slider slips to open the teeth.

Match two

By pulling the head, it can be drawn or pulled at will.

When the pull head moves forward, the chain teeth on the two chain teeth are restricted by the shape of the closed angle of the inner cavity of the drawing head, thus being meshed with each other, thus forming a closed state of the garment zipper.

When the top is pulled to the top of the garment zipper, the width of the upper closure is greater than the width of the narrowest part of the inner cavity of the drawing head, which has a function of limiting the pulling head, so that the pull head does not fall off the chain belt. When the pull head is pulled back, the teeth of the chain teeth are separated from each other by the split angle (the dihedral angle) formed by the cylinders on both sides of the pulling column, so that the two chain bands are separated.

When the drawing head is pulled to the bottom of the chain, the width of the top and bottom ends is greater than the width of the inner cavity of the drawing head, so that the pulling head does not fall off the chain belt.